1469

UnclassifiedGeneral

What This Code Means

Measured speed and measured AC output frequency do not agree; Engine shutdown

Possible Causes

  • •Faulty Magnetic Pick-up
  • •Fly Wheel Teeth Number Is Incorrectly Set
  • •Flywheel teeth number is incorrectly set
  • •Incorrect Engine Speed Data
  • •Incorrect flywheel teeth configuration setup
  • •Measured engine speed and measured alternator AC output frequency do not agree
  • •Speed Hz Match conflict shutdown fault condition active for the duration of the time delay
  • •Speed and AC output frequency mismatch
  • •Speed/frequency conflict active for the duration of the time delay

Suggested Actions

  1. 1Access the Flywheel Teeth setup screen through the Operator Panel and ensure that the PCC is set up with the correct number of engine flywheel teeth.
  2. 2Check the genset setup for number of flywheel teeth
  3. 3If the MPU tests satisfactorily, then check the voltage output of the board at J11-9 (MPU +) and J11-10 (MPU -).
  4. 4Inspect the MPU wires/connector pins for shorts and open circuits.
  5. 5Refer to the engine service manual to correct.
  6. 6Remove the MPU connectors and check for 3.5 to 15 VAC at the MPU while cranking.
  7. 7Through the operator panel verify the engine speed by going to Engine Data > Engine Speed.

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 1469 on your specific Cummins unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.