* SD START FAIL
UnclassifiedFuel
What This Code Means
Alarm message '* Wrn Air Filter Clogging Up' appears during operation; Air cleaner element becomes clogged during operation; Alarm message '* Wrn Fuel Level' appears; Breaker is shut off during operation; Equipment is automatically stopped; Breaker shuts off during operation; Engine fails to start; Alarm message '* Sd Start Fail' appears; Engine is automatically stopped; Breaker shuts off and automatically stops; Breaker shuts off; Engine automatically stops
Possible Causes
- •Air cleaner element becomes clogged
- •Amount of fuel is small
- •Overcurrent is detected during operation
- •Short circuit is detected during operation
- •Terminal cover is opened during operation
- •Over Crank (Engine fails to start)
- •Air cleaner element becomes clogged during operation
- •The amount of fuel is small
- •Overcurrent detected during operation
- •Short circuit detected during operation
- •Engine fails to start (Over Crank)
Suggested Actions
- 1Immediately stop the engine and clean or replace the air cleaner element
- 2Check if there is a sufficient amount of fuel and add fuel
- 3Use equipment so as not to exceed the rated current
- 4Close the terminal cover, turn off the breaker, and then turn it on again
- 5Set the Power Switch to Stop, and inspect the machine
- 6Immediately stop the engine
- 7Clean or replace the air cleaner element
- 8Check if there is a sufficient amount of fuel
- 9Add fuel if insufficient
- 10Reduce load so as not to exceed the rated current
- 11Close the terminal cover
- 12Turn off the breaker, and then turn it on again
- 13Set the Power Switch to Stop
- 14Inspect the machine
Related Shindaiwa Fault Codes
ASK RUDY ABOUT THIS FAULT
Get a diagnosis walkthrough for * SD START FAIL on your specific Shindaiwa unit — cited to the OEM manual, not a forum guess.
TRY IT FREE