BATT CHG FLT

UnclassifiedCooling

What This Code Means

AC Sensing Lost; Accessory Power Overload; High generator current detected; Generator set shuts down to protect the alternator from damage caused by overheating the windings; RXT interface connection is lost; Transfer switch phase rotation does not match; ATS will not transfer; Optional customer-connected input is closed; Battery charger fault; Engine starting battery voltage rises above 125% of the battery voltage setting for more than 10 seconds; Engine starting battery voltage falls below the battery voltage setting (typically 12.5 volts) for more than 90 seconds when the engine is not running

Possible Causes

  • •Eingang an PIM von externem Batterieladegerät
  • •Entrée vers le PIM d’un chargeur d’accumulateur externe (pas du chargeur intégré)
  • •Erreur de chargeur d’accumulateur (entrée vers le PIM d’un chargeur d’accumulateur externe)
  • •Erreur de chargeur d’accumulateur (signalée au niveau de l'entrée vers le PIM d’un chargeur d’accumulateur externe)
  • •Fault input to PIM from an external battery charger
  • •Fault input to PIM from an external battery charger (not the built-in battery charger)
  • •Fehler am Eingang an PIM von externem Batterieladegerät
  • •Generator output AC sensing is lost
  • •High engine starting battery voltage
  • •High generator current
  • •Input signal to PIM from an external battery charger
  • •Input to PIM from an external battery charger (not the built-in battery charger)
  • •Input to PIM from an external battery charger (not the built-in battery charger) indicates a fault
  • •Low engine starting battery voltage
  • •Optional customer-connected input is closed (Digital input from optional PIM.)
  • •Over current fault (short circuit) on the accessory controller power output
  • •Probleem met invoer naar PIM vanaf externe acculader
  • •RXT interface connection is lost
  • •Señal de falla en la entrada al PIM desde un cargador de batería externo (no el cargador integrado de la batería)
  • •Señales de falla en la entrada al PIM desde un cargador de batería externo
  • •Storing in invoer naar PIM vanaf externe acculader
  • •Transfer switch phase rotation does not match

Suggested Actions

  1. 1Check communication wiring between transfer switch interface board and generator set
  2. 2Check customer-supplied equipment
  3. 3Check external battery charger
  4. 4Check the battery charger operation
  5. 5Check the battery rating and condition
  6. 6Contact an authorized distributor/dealer for service
  7. 7Controleer de externe acculader
  8. 8Contrôler le chargeur d’accumulateur externe
  9. 9Correct the ATS connection
  10. 10Externes Batterieladegerät prüfen
  11. 11Reduce the load
  12. 12Refer to the ATS Installation manual, wiring diagrams, and labels on the transfer switch
  13. 13Revise el cargador de batería externo

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for BATT CHG FLT on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.