ATS PHASEROT

UnclassifiedCooling

What This Code Means

AC Sensing Lost; Accessory Power Overload; High generator current detected; Generator set shuts down to protect the alternator from damage caused by overheating the windings; RXT interface connection is lost; Transfer switch phase rotation does not match; ATS will not transfer; Optional customer-connected input is closed; Battery charger fault; Engine starting battery voltage rises above 125% of the battery voltage setting for more than 10 seconds; Engine starting battery voltage falls below the battery voltage setting (typically 12.5 volts) for more than 90 seconds when the engine is not running

Possible Causes

  • •ATS phase rotation mismatch
  • •ATS-Phasendrehung ist nicht abgestimmt
  • •Die ATS-Phasendrehung ist nicht abgestimmt (ATS-Phasendrehungsunterschied)
  • •El giro de la fase del interruptor de transferencia no coincide
  • •Faserotatie transferschakelaar komt niet overeen
  • •Generator output AC sensing is lost
  • •High engine starting battery voltage
  • •High generator current
  • •Input to PIM from an external battery charger (not the built-in battery charger)
  • •Low engine starting battery voltage
  • •L’ordre de raccordement des phases du commutateur de transfert n’est pas correct
  • •Optional customer-connected input is closed (Digital input from optional PIM.)
  • •Ordre de raccordement des phases du ATS incorrect
  • •Over current fault (short circuit) on the accessory controller power output
  • •RXT interface connection is lost
  • •Transfer switch phase rotation does not match

Suggested Actions

  1. 1ATS-Installationsanleitung, Stromlaufpläne und Aufkleber auf ATS beachten
  2. 2Check communication wiring between transfer switch interface board and generator set
  3. 3Check customer-supplied equipment
  4. 4Check external battery charger
  5. 5Check the battery charger operation
  6. 6Check the battery rating and condition
  7. 7Consulte el manual de instalación del ATS, los diagramas de cableado y las etiquetas en el interruptor de transferencia
  8. 8Consulter le manuel d’installation du ATS, les schémas de câblage et les étiquettes sur le commutateur
  9. 9Contact an authorized distributor/dealer for service
  10. 10Correct the ATS connection
  11. 11Corrigeer de ATS-verbinding
  12. 12Corrija la conexión del ATS
  13. 13Den ATS-Anschluss korrigieren
  14. 14Raadpleeg de ATS-installatiehandleiding, -bedradingsschema's en de etiketten op de transferschakelaar
  15. 15Raadpleeg de ATS-installatiehandleiding, bedradingsschema’s en de etiketten op de transferschakelaar
  16. 16Rectifier le raccordement du commutateur de transfert
  17. 17Reduce the load
  18. 18Refer to the ATS Installation manual, wiring diagrams, and labels on the transfer switch
  19. 19Siehe ATS-Installationsanleitung, -Stromlaufpläne und Aufkleber auf ATS
  20. 20Voir le manuel d’installation du ATS, les schémas de câblage et les étiquettes sur le commutateur
  21. 21Voir le manuel d’installation du commutateur de transfert, les schémas de câblage et les étiquettes sur le commutateur

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for ATS PHASEROT on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.