AUX INPUT

UnclassifiedCooling

What This Code Means

AC Sensing Lost; Accessory Power Overload; High generator current detected; Generator set shuts down to protect the alternator from damage caused by overheating the windings; RXT interface connection is lost; Transfer switch phase rotation does not match; ATS will not transfer; Optional customer-connected input is closed; Battery charger fault; Engine starting battery voltage rises above 125% of the battery voltage setting for more than 10 seconds; Engine starting battery voltage falls below the battery voltage setting (typically 12.5 volts) for more than 90 seconds when the engine is not running

Possible Causes

  • •An optional customer-connected digital input from optional PIM is closed
  • •An optional customer-connected input is closed
  • •An optional customer-connected input is closed (digital input from optional PIM)
  • •Auxiliary input closed (digital input from optional PIM)
  • •Digitale invoer van optionele PIM afgesloten
  • •Een optionele klant-verbonden invoer wordt afgesloten (digitale invoer van optionele PIM)
  • •Ein optionaler, vom Kunden angeschlossener Eingang ist geschlossen (Digitaleingang von optionalem PIM)
  • •Entrée numérique du client en option fermée (issue du PIM en option)
  • •Generator output AC sensing is lost
  • •High engine starting battery voltage
  • •High generator current
  • •Input to PIM from an external battery charger (not the built-in battery charger)
  • •Low engine starting battery voltage
  • •Optional customer-connected input is closed (Digital input from optional PIM.)
  • •Optionaler, vom Kunden angeschlossener Eingang ist geschlossen (Digitaleingang von optionalem PIM)
  • •Over current fault (short circuit) on the accessory controller power output
  • •RXT interface connection is lost
  • •Transfer switch phase rotation does not match
  • •Una entrada opcional conectada por el cliente está cerrada (Entrada digital de PIM opcional)
  • •Une entrée du client en option est fermée (entrée numérique issue du PIM en option)

Suggested Actions

  1. 1Check communication wiring between transfer switch interface board and generator set
  2. 2Check customer-supplied equipment
  3. 3Check external battery charger
  4. 4Check the battery charger operation
  5. 5Check the battery rating and condition
  6. 6Contact an authorized distributor/dealer for service
  7. 7Controleer door de klant-aangeleverde apparatuur
  8. 8Contrôler le matériel fourni par le client
  9. 9Correct the ATS connection
  10. 10Kundenausrüstung prüfen
  11. 11Reduce the load
  12. 12Refer to the ATS Installation manual, wiring diagrams, and labels on the transfer switch
  13. 13Revise los equipos proporcionados por el cliente

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for AUX INPUT on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.