427/781

UnclassifiedSpeed

What This Code Means

Warning level fault issued by control when CAN datalink is lost and there is no engine speed or no start command; Shutdown level fault issued by control when CAN datalink is lost while there is a non-zero engine speed or a start command is active

Possible Causes

  • •Communication link between the engine controller and genset controller is lost
  • •The networking harness is defective
  • •The ECM is powered down
  • •Base board is defective

Suggested Actions

  1. 1Check the datalink between the ECM and the GCS for opens or shorts between J11-20 (CANH), J11-19 (CANL), and J11-17 (CAN Shield)
  2. 2Check for 60 Ohms resistance between J11-20 and J11-19; if not present, repair the harness
  3. 3With control powered, check for B+ on the positive side of the keyswitch pilot relay coil and GND on the negative side of the keyswitch relay coil
  4. 4If B+ doesn't exist, repair the harness
  5. 5If GND doesn't exist on the negative side of the keyswitch relay coil, check for GND on P11-21 (Keyswitch LS Out)
  6. 6If GND exists on P11-21, repair the harness
  7. 7If GND doesn't exist on P11-21, replace the defective Base board

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 427/781 on your specific Cummins unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.