2623

Possible Causes

• •Analog Input #4 Sensor Type parameter set to active low with an active high signal
• •Analog Input #4 active state selection parameter is configured incorrectly
• •Condition for which Analog Input #4 is configured is active
• •Incorrectly wired
• •Incorrectly wired, or open circuit or short circuit in the wiring
• •Incorrectly wired; or open circuit or short circuit in the wiring
• •Open circuit in the wiring
• •Short circuit in the wiring

Suggested Actions

1. 1After the issue is resolved, press the Reset button on the Operator Panel in order to clear the fault
2. 2After the issue is resolved, press the Reset button on the Operator Panel in order to clear the fault, if the fault does not clear go to next step.
3. 3Check the condition for which "Analog Input #4" has been configured for.
4. 4Check the condition for which Analog Input #4 has been configured for
5. 5Check the wiring at J11-7 (reference input 1) and J11-8 (switch input) for an open circuit, short circuit, or a miswired condition
6. 6Check the wiring at J11-7 (reference input 1) and J11-8 (switch input) for an open circuit, short circuit, or a miswired condition.
7. 7Press the Reset button on the Operator Panel in order to clear the fault
8. 8With InPower or through the Operator Panel check the switch input setting (active closed or active open) for Analog Input #4 and ensure that the switch input setting is correctly set
9. 9With InPower or through the Operator Panel check the switch input setting (active closed or active open) for Analog Input #4. Ensure that the switch input setting is correctly set.
10. 10With InPower or through the Operator Panel, check the switch input setting (active closed or active open) for Analog Input #4 and ensure that it is correctly set

Related Cummins Fault Codes