UNDERFREQUENCY

UnclassifiedElectrical

What This Code Means

LED display communicates faults; Generator shut down; Controller displays fault (underspeed, underfrequency, or undervoltage)

Possible Causes

  • •Blocked air inlets
  • •Blocked exhaust outlets
  • •Excess heat inside the enclosure
  • •Faulty or loose source connections
  • •Frequency settings
  • •Frequency settings incorrect
  • •Frequency settings mismatch or incorrect pickup/dropout/debounce settings
  • •High battery voltage
  • •High engine temperature
  • •Incorrect frequency settings
  • •Loose or faulty source connections
  • •Loose source connections or wiring fault
  • •Low battery voltage
  • •Low oil pressure
  • •Overcrank safety
  • •Overfrequency
  • •Overspeed
  • •Overvoltage
  • •Source availability or stability issue
  • •Source availability or stability issues
  • •Source availability, stability
  • •Source availability, stability issues
  • •Source connections
  • •Source frequency is below the under frequency dropout setting
  • •Thermostat trip (e.g., nuisance trip)
  • •Thermostat tripped due to excess heat inside the enclosure
  • •Thermostat trips
  • •Underfrequency
  • •Undervoltage

Suggested Actions

  1. 1Check for blocked air inlets and exhaust outlets
  2. 2Check for blocked air inlets and exhaust outlets.
  3. 3Check for loose connections
  4. 4Check for loose connections and check wiring
  5. 5Check that the frequency debounce setting is long enough to prevent nuisance faults caused by brief frequency variations
  6. 6Check that the source frequency matches the nominal system frequency and stays within the range of the pickup and dropout settings
  7. 7Check that the system frequency setting matches the actual source frequency (50 or 60 Hz)
  8. 8Check the over/under frequency pickup and dropout settings
  9. 9Check the over/underfrequency pickup and dropout settings
  10. 10Check the over/underfrequency pickup and dropout settings (See Section 3.9.3 and the Setup Program Operation Manual)
  11. 11Check wiring
  12. 12Disconnect the utility power to the generator by opening (turning OFF) the corresponding circuit breaker at the building's distribution panel
  13. 13Open the enclosure roof and secure it with the roof stay on the left side of the enclosure
  14. 14Press the button on the thermostat to reset it
  15. 15Reconnect utility power to the generator set by closing the circuit breaker in the distribution panel
  16. 16Remove the air intake panel
  17. 17Replace the air intake panel
  18. 18Reset the fault on the controller
  19. 19Reset the thermostat
  20. 20Reset the thermostat.

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for UNDERFREQUENCY on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.