UNDERVOLTAGE

UnclassifiedElectrical

What This Code Means

LED display communicates faults; Generator shut down; Controller displays fault (underspeed, underfrequency, or undervoltage)

Possible Causes

  • •Blocked air inlets
  • •Blocked exhaust outlets
  • •Calibration error
  • •Excess heat inside the enclosure
  • •Faulty or loose source connections
  • •High battery voltage
  • •High engine temperature
  • •Incorrect voltage settings
  • •Loose or faulty source connections
  • •Loose source connections or wiring fault
  • •Low battery voltage
  • •Low oil pressure
  • •Overcrank safety
  • •Overfrequency
  • •Overspeed
  • •Overvoltage
  • •Source availability or stability issue
  • •Source availability or stability issues
  • •Source availability, stability issues
  • •Thermostat trip (e.g., nuisance trip)
  • •Thermostat tripped due to excess heat inside the enclosure
  • •Thermostat trips
  • •Underfrequency
  • •Undervoltage
  • •Voltage settings
  • •Voltage settings incorrect
  • •Voltage settings mismatch or incorrect pickup/dropout/debounce settings

Suggested Actions

  1. 1Check for blocked air inlets and exhaust outlets
  2. 2Check for blocked air inlets and exhaust outlets.
  3. 3Check for loose connections
  4. 4Check for loose connections and check wiring
  5. 5Check that the source voltage matches the nominal system voltage and stays within the range of the pickup and dropout settings
  6. 6Check that the system voltage setting matches the actual source voltage
  7. 7Check that the voltage debounce setting is long enough to prevent nuisance faults caused by brief voltage dips or spikes
  8. 8Check the ATS calibration
  9. 9Check the ATS meter calibration (See TP-6135, Setup Program Operation Manual)
  10. 10Check the over/undervoltage pickup and dropout settings
  11. 11Check the over/undervoltage pickup and dropout settings (See Section 3.9.3 and the Setup Program Operation Manual)
  12. 12Check wiring
  13. 13Disconnect the utility power to the generator by opening (turning OFF) the corresponding circuit breaker at the building's distribution panel
  14. 14Open the enclosure roof and secure it with the roof stay on the left side of the enclosure
  15. 15Press the button on the thermostat to reset it
  16. 16Reconnect utility power to the generator set by closing the circuit breaker in the distribution panel
  17. 17Remove the air intake panel
  18. 18Replace the air intake panel
  19. 19Reset the fault on the controller
  20. 20Reset the thermostat
  21. 21Reset the thermostat.

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for UNDERVOLTAGE on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.