PROGRAMMABLE ALARM 1
UnclassifiedSensors
What This Code Means
Controller does not switch on the Genset change over; Engine stops with cooling (Stop with engine cooling); Programmable alarm 1 triggers; Engine stop; Engine stop-inducing alarms; Warnings which do not stop the engines; Programmable alarm 1 is triggered; Associated programmable text appears on the visualization module display; Programmable alarm 2 is triggered
Possible Causes
- •Coolant temperature value is under the programmed limits (Thresholds table parameter 28)
- •No voltage is detected in any of the phases while the engine is running
- •Status of associated digital input (ENT1, ENT2, ENT3, ENT4, or ENT5) is validated during stabilization time (Times table parameter 19, 20, 22, 23, or 24)
- •Emergency stop alarm activation
- •Low oil pressure alarm activation
- •High coolant temperature alarm activation
- •Thermal protection alarm activation
- •Programmable alarm activation
- •Poor quality of the mains signal
- •General digital input status validated during stabilization time
- •General digital input (ENT1, ENT2, ENT3, ENT4 or ENT5) status validated during stabilization time
Suggested Actions
- 1Allow the engine to exceed the low temperature limits (Thresholds table parameter 28)
Related Himoinsa Fault Codes
ASK RUDY ABOUT THIS FAULT
Get a diagnosis walkthrough for PROGRAMMABLE ALARM 1 on your specific Himoinsa unit — cited to the OEM manual, not a forum guess.
TRY IT FREE