Himoinsa

LOW ENGINE TEMPERATURE

UnclassifiedSensors

What This Code Means

Controller does not switch on the Genset change over; Engine stops with cooling (Stop with engine cooling); Programmable alarm 1 triggers

Possible Causes

  • •Coolant temperature value is under the programmed limits (Thresholds table parameter 28)
  • •No voltage is detected in any of the phases while the engine is running
  • •Status of associated digital input (ENT1, ENT2, ENT3, ENT4, or ENT5) is validated during stabilization time (Times table parameter 19, 20, 22, 23, or 24)

Suggested Actions

  1. 1Allow the engine to exceed the low temperature limits (Thresholds table parameter 28)

Related Himoinsa Fault Codes

PROGRAMMABLE ALARM 1GENSET SIGNAL FAILUREFUEL STORAGE WARNINGLOW FUEL LEVEL BY SENSORLOW FUEL LEVEL BY SENSOR ALARMLOW COOLANT LEVELLOW OIL PRESSURELOW BATTERY VOLTAGE AT THE STARTING ALARMLOW OIL PRESSURE BY SENSORLOW BATTERY VOLTAGE AT THE STARTINGLOW OIL PRESSURE BY SENSOR ALARMLOW BATTERY VOLTAGE
Browse all Himoinsa fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for LOW ENGINE TEMPERATURE on your specific Himoinsa unit — cited to the OEM manual, not a forum guess.

TRY IT FREE