Himoinsa

GENSET SIGNAL FAILURE

UnclassifiedSensors

What This Code Means

Controller does not switch on the Genset change over; Engine stops with cooling (Stop with engine cooling); Programmable alarm 1 triggers

Possible Causes

  • •Coolant temperature value is under the programmed limits (Thresholds table parameter 28)
  • •No voltage is detected in any of the phases while the engine is running
  • •Status of associated digital input (ENT1, ENT2, ENT3, ENT4, or ENT5) is validated during stabilization time (Times table parameter 19, 20, 22, 23, or 24)

Suggested Actions

  1. 1Allow the engine to exceed the low temperature limits (Thresholds table parameter 28)

Related Himoinsa Fault Codes

LOW ENGINE TEMPERATUREPROGRAMMABLE ALARM 1FUEL STORAGE WARNINGGENSET VOLTAGE ASYMMETRY ALARMHCTHIGH BATTERY VOLTAGEHIGH BATTERY VOLTAGE ALARMFUEL RESERVEHIGH COOLANT TEMPERATUREFR
Browse all Himoinsa fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for GENSET SIGNAL FAILURE on your specific Himoinsa unit — cited to the OEM manual, not a forum guess.

TRY IT FREE