OVER CRANK

UnclassifiedCooling

What This Code Means

Three unsuccessful starting attempts; Engine speed sensor failure; Engine stalled; Generator voltage high; Output voltage exceeds 120% of the system nominal voltage for more than 2 seconds; Generator voltage low; Output voltage falls below 80% of the nominal system voltage for more than 10 seconds; Over current fault on the 70 controller power output; MAP Sensor High input voltage; Engine ECM indicates low oil pressure

Possible Causes

  • •Battery fault
  • •Battery issue
  • •Battery issues
  • •Bougies défaillantes
  • •Erfolglose Anlassversuche
  • •Failed engine speed sensor
  • •Faulty spark plug
  • •Faux contact
  • •Fuel supply fault
  • •Fuel supply issue
  • •Fuel supply issues
  • •Generated by the engine ECM
  • •Generator voltage high
  • •Generator voltage low
  • •Issues with fuel supply, spark plug, battery, or wiring connections
  • •Leaks in the lubrication system
  • •Loose connections
  • •Loose electrical connections
  • •Low oil level
  • •Problème d'accumulateur
  • •Problème d'arrivée de combustible
  • •Short circuit
  • •Spark plug fault
  • •Spark plug issue
  • •Three failed starting attempts
  • •Three unsuccessful starting attempts

Suggested Actions

  1. 1Auf lose Anschlüsse prüfen
  2. 2Bei einem autorisierten Distributor oder Händler um Service anfragen
  3. 3Check battery
  4. 4Check enclosure thermostat and reset if tripped (Model 20RESC/20RESCL only)
  5. 5Check for loose connections
  6. 6Check for loose connections.
  7. 7Check for signs of leaks in the lubrication system.
  8. 8Check fuel supply
  9. 9Check spark plug
  10. 10Check spark plugs
  11. 11Check the engine oil level regularly as recommended in section titled: Scheduled Maintenance.
  12. 12Check the fuel supply, spark plug, and battery
  13. 13Check the fuel supply, spark plug, and battery.
  14. 14Check the oil level and add oil if the level is low.
  15. 15Contact an authorized dealer for service
  16. 16Contact an authorized dealer for service.
  17. 17Contact an authorized distributor/dealer for service
  18. 18Contact an authorized distributor/dealer for service.
  19. 19Contact authorized dealer/distributor for service
  20. 20Contrôler l'accumulateur
  21. 21Contrôler l'arrivée de combustible
  22. 22Contrôler les bougies
  23. 23Contrôler l’arrivée de combustible, les bougies et l’accumulateur
  24. 24Reduce the load
  25. 25Restart the generator set
  26. 26S'adresser à un concessionnaire/distributeur agréé
  27. 27S’adresser à un distributeur/ concessionnaire agréé
  28. 28Treibstoffversorgung, Zündkerze und Batterie prüfen
  29. 29Vérifier qu'il n'y a pas de faux contact
  30. 30Vérifier qu’il n’y a pas de faux contact

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for OVER CRANK on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.