FG Wilson

NOT IN AUTO MODE

UnclassifiedGeneral

What This Code Means

Alarm for Not In Auto Mode (Standby sets only); Amber LED illuminates

Possible Causes

  • •Generator control not set to Auto mode
  • •Generator set is not in auto mode (standby sets)
  • •PowerWizard is not being used in AUTO mode
  • •PowerWizard is not configured or running in AUTO mode
  • •PowerWizard is not in AUTO mode
  • •PowerWizard is not operating in AUTO mode

Suggested Actions

  1. 1Check Emergency Stop push buttons are not pressed
  2. 2Check Emergency Stop pushbuttons are not pressed
  3. 3Check the module is in "Auto" mode
  4. 4Check the module is in 'Auto' mode
  5. 5Ensure the generator set is in Stop mode before editing event configurations
  6. 6Ensure the generator set is in Stop mode to edit configuration
  7. 7Navigate to Main Menu -> Configure -> All setpoints -> Events -> Other System Config
  8. 8Navigate to: Main Menu -> Configure -> All setpoints -> Events -> Other System Config
  9. 9Press AUTO Key
  10. 10Refer to your local dealer
  11. 11Scroll down to “Gen Control Not in Auto Warning Config”
  12. 12Use the left key to turn off a response and press enter to keep selection
  13. 13Use the left key to turn off a response and press enter to keep your selection
  14. 14Use the right key to select Edit and press enter

Related FG Wilson Fault Codes

FAIL TO STOPCAN ECU WARNINGCAN ECU SHUTDOWNCAN DATA FAILOVER-VOLTAGEOVERSPEEDLOW OIL PRESSUREOVERSPEED FAULTHIGH ENGINE TEMPERATUREUNDER-VOLTAGEHIGH COOLANT TEMP
Browse all FG Wilson fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for NOT IN AUTO MODE on your specific FG Wilson unit — cited to the OEM manual, not a forum guess.

TRY IT FREE