DTC 604

UnclassifiedGeneral

What This Code Means

DTC 604 resets with engine idling

Possible Causes

  • •Faulty ECM
  • •Faulty power and ground circuits to ECM
  • •Faulty wiring to ECM
  • •Intermittent fault

Suggested Actions

  1. 1Carefully check resistance between Knock 1 (+) output at ECM header and knock sensor connector by probing on the side of the terminal (do not insert probe or object into terminals to prevent spreading pins)
  2. 2Carefully check resistance between MAP input at ECM header and signal at device by probing on the side of the terminal (avoid inserting probes into terminals to prevent spreading pins)
  3. 3Carefully remove yellow lock from header at device output terminal
  4. 4Check ECM power and ground circuits
  5. 5Check all power and ground circuits to ECM
  6. 6Check battery voltage in DST
  7. 7Check if DST displays ECT voltage greater than calibration limit with Key ON, Engine Off (System Mode = 'Stopped').
  8. 8Check if DST displays TIP pressure greater than defined in the diagnostic calibration with Key ON, Engine ON, and System Mode set to 'Running'
  9. 9Check resistance between Knock 1 (+) and ground and 5Vrtn1 (Analog Return)
  10. 10Check wire harness for a ground short
  11. 11Check wire harness for ground short
  12. 12Clear DTC information from the ECM, operate engine to full operating temperature, and check for stored codes
  13. 13Clear system fault
  14. 14Clear system fault codes using a Diagnostic Scan Tool (DST) in System Data Mode
  15. 15Connect TPS1 signal to the 5V reference at throttle connector while observing TPS 1 voltage, repeat for TPS2, and check if DST displays both TPS1 and TPS2 voltage over 4.90 VDC.
  16. 16Connect TPS1 signal to the 5V reference at throttle connector while observing TPS1 voltage, repeat for TPS2, and check if DST displays both TPS1 and TPS2 voltage over 4.90 VDC.
  17. 17Correct the ECM wire harness or connector problem
  18. 18Disconnect ECT sensor from harness, jumper across terminals at connector, and check if DST displays ECT voltage of 0.1 or less.
  19. 19Disconnect FT sensor from harness to test voltage
  20. 20Disconnect IAT sensor from harness and jumper across terminal at connector to check if DST displays IAT voltage of 0.1 or less
  21. 21Perform On-Board (OBD) System Check
  22. 22Repair wiring to ECM and retest
  23. 23Replace ECM with known good part and retest

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for DTC 604 on your specific Power Solutions International, Inc. unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.