Power Solutions International, Inc.

DTC 236

UnclassifiedLubrication

What This Code Means

MIL on; Adaptive disabled; Throttle inlet pressure (TIP) reading less than 16 psia while manifold absolute pressure (MAP) is at or above 18 psia

Possible Causes

  • •Reversed wiring or swapped connectors between the TIP and MAP sensors
  • •TIP sensor not properly installed in the CAC piping
  • •Loose TIP sensor retaining bolt
  • •Damaged TIP sensor
  • •Faulty TIP sensor

Suggested Actions

  1. 1Verify that the wiring for the TIP and MAP sensors is not reversed (TIP sensor should have three wires at the connector; MAP sensor should have four wires)
  2. 2Ensure the TIP sensor is fully installed into the CAC piping and the retaining bolt is tight
  3. 3Remove and inspect the TIP sensor for damage
  4. 4Replace the TIP sensor with a known good part and test again

Related Power Solutions International, Inc. Fault Codes

DTC 520DTC 524522DTC 2229341DTC1172238OTC 52 4129DTC 237DTC 238DTC 234
Browse all Power Solutions International, Inc. fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for DTC 236 on your specific Power Solutions International, Inc. unit — cited to the OEM manual, not a forum guess.

TRY IT FREE