Power Solutions International, Inc.

DTC 22 2

UnclassifiedFuel

What This Code Means

TPS 2 Signal Voltage Low; TPS2 voltage < 1.00 VDC at 0% TPS; DST displays TPS2 voltage <0.2 VDC with the throttle closed; DST displays TPS2 voltage <0.2 VDC with the throttle open; TPS2 voltage falls below 0.2 volts when releasing FPP sensor

Possible Causes

  • •Intermittent Problem
  • •Poor Throttle Connection
  • •Faulty Throttle

Suggested Actions

  1. 1Perform the On-Board (OBD) System Check.
  2. 2Key ON, Engine OFF, set System Mode to 'Stopped', enable 'DBW Test' mode, and check if TPS2 voltage is low (< 1.00 VDC) at 0% TPS.
  3. 3Observe if DST displays TPS2 voltage <0.2 VDC with the throttle closed.
  4. 4Slowly depress FP (or sweep throttle on stationary applications by typing the desired throttle opening % in the TPS Command box on the DBW page) and observe if DST displays TPS2 voltage <0.2 VDC with the throttle open.
  5. 5Key OFF and disconnect throttle from harness.
  6. 6Slowly release FPP sensor while observing if TPS2 voltage falls below 0.2 volts.
  7. 7Jumper 5Vref1 to TPS2 signal circuit at throttle connector, set Key On, Engine Off, System Mode = 'Stopped', and check if DST displays TPS2 voltage >4.0 VDC.

Related Power Solutions International, Inc. Fault Codes

DTC 223DTC 11111164DTC 11521162DTC 21121154148DTC 89 20DTC 107DTC 18 7DTC 108
Browse all Power Solutions International, Inc. fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for DTC 22 2 on your specific Power Solutions International, Inc. unit — cited to the OEM manual, not a forum guess.

TRY IT FREE