1613

UnclassifiedGeneral

What This Code Means

DTC 1613 resets with engine idling

Possible Causes

  • •Fault is intermittent
  • •Faulty ECM
  • •Faulty power or ground circuits to ECM
  • •Intermittent fault

Suggested Actions

  1. 1Check all power and ground circuits to ECM
  2. 2Perform On-Board (OBD) System Check
  3. 3Recompile with latest software and re-flash the ECM
  4. 4Repair wiring to ECM and retest
  5. 5Replace ECM with known good part and retest
  6. 6Check for continuity between ECM wire harness header connector pin 33 and engine ground
  7. 7Check harness continuity for the specific coil circuit wire leading from the ECM to the ignition coil
  8. 8Check if DST displays DTC 652 with Key ON, Engine Running, and System Mode set to 'Running'
  9. 9Check resistance between Knock 1 (+) and ground and 5Vrtn1 (Analog Return)
  10. 10Check resistance between Knock 1 (+) and ground and 5Vrtn1 (Analog Return) (resistance should be <5.0 ohms)
  11. 11Check resistance between Knock 1 (+) output at ECM header and knock sensor connector
  12. 12Check the ECM, crankshaft position sensor, and ignition timing settings if there is no ECM trigger signal
  13. 13Check wire harness for ground short
  14. 14Clear DTC 521
  15. 15Clear DTC information from the ECM using the Diagnostic Scan Tool (DST)
  16. 16Clear System Fault
  17. 17Clear System Fault (Key On, Engine Running, System Data Mode)
  18. 18Connect TPS1 and TPS2 signal to the 5V reference at throttle connector and verify if DST displays voltage over 4.90 VDC.
  19. 19Disconnect ECT sensor from harness, jumper across terminals at connector, and check if DST displays ECT voltage of 0.1 or less.
  20. 20Disconnect FT sensor from harness

Related Power Solutions International Fault Codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 1613 on your specific Power Solutions International unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.