144

UnclassifiedCooling

What This Code Means

Engine has begun to overheat; Engine coolant temperature has risen to an unacceptable level; Engine is operating near cooling system capacity; Engine has overheated; Coolant temperature has risen above the shutdown trip point; Coolant level is low

Possible Causes

  • •Coolant leakage
  • •Coolant temperature sensor output is out of range (OOR), low
  • •Coolant temperature sensor signal is out of range − shorted high or low
  • •Defective Base board
  • •Defective harness
  • •Defective sensor
  • •Faulty blower fan or circulation pumps on remote radiator installations
  • •Faulty engine coolant temperature sender, connectors, or wires
  • •Higher ambient temperature
  • •Increase in load
  • •Loose or damaged fan belt
  • •Low coolant level
  • •Obstructions to cooling airflow

Suggested Actions

  1. 1Allow the engine to cool down completely before proceeding with checks.
  2. 2Check for obstructions to cooling airflow and correct as necessary.
  3. 3Check the blower fan and circulation pumps on remote radiator installations.
  4. 4Check the coolant level and replenish if low.
  5. 5Check the fan belt and repair or tighten if necessary.
  6. 6Check the sender/connectors/wires
  7. 7Consult the engine service manual
  8. 8Disconnect the sensor and plug in a resistive sensor simulator to isolate the fault. If the control responds to the simulator, replace the sensor. If control does not respond, go to the next step.
  9. 9Look for possible coolant leakage points and repair if necessary.
  10. 10Measure the resistance of the coolant sensor and reconnect the harness to the sensor. Remove connector P11 from the Base board and check resistance between pins P11-11 (H20) and P11-12 (H20 COM). If resistance is not the same, replace the harness. If resistance is the same, replace the Base board.
  11. 11Remove connector P11 from the Base board and disconnect the sensor. Check pins P11-11 (H20) and P11-12 (H20 COM) for a short circuit to the engine block ground (more than 200k ohms is OK) and from pin to pin (more than 200k ohms is OK). Repair or replace as necessary.
  12. 12Review fault code 151 correction list for other possible causes.

Related Cummins Fault Codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 144 on your specific Cummins unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.