Generac

10

UnclassifiedCooling

What This Code Means

Overload condition; Load management modules forced into load shed function; Low fuel indicator active; Low coolant indicator active; Low oil pressure indicator active; The ignition fails to spark; The ignition quits sparking; Not enough outputs on the ignition module for the cylinder setup

Possible Causes

  • •Load management modules are used
  • •Overload setting is ON
  • •Fuel level below 5 units
  • •Coolant level is low
  • •Oil pressure below 8 psi (55 kPa)
  • •The signal relationship between the CAM and crank is out of sync.
  • •Nexus setup to run a 10 cylinder with a 6 output ignition module.

Suggested Actions

  1. 1Perform a hard reset

Related Generac Fault Codes

451809100181100711016-812006-71201
Browse all Generac fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 10 on your specific Generac unit — cited to the OEM manual, not a forum guess.

TRY IT FREE