Deep Sea Electronics

SD CAN SPEED DEMAND 250

UnclassifiedSpeed

What This Code Means

Speed control is not available; Warning error code 'SD CAN SPEED DEMAND 250' displayed; Synchronization commissioning requires fine tuning

Possible Causes

  • •Using MTU MDEC303 CAN file with a version 304 MDEC engine
  • •Use of MTU MDEC304 CAN file (or higher) with DSE Load Share Controllers

Suggested Actions

  1. 1Use MTU MDEC304 CAN file
  2. 2Use MTU MDEC504 CAN file
  3. 3Refer to MTU to verify MDEC version
  4. 4Configure SW1 setting to 5.0
  5. 5Configure SW2 setting to 4.0
  6. 6Perform DSE Four Steps to Successful Synchronisation Commissioning

Related Deep Sea Electronics Fault Codes

FAIL TO STARTSPN 100, FMI 1SPN 100, FMI 3OIL SENDER OPEN CIRCUITSPN 100, FMI 5OIL FILTER MAINTENANCE ALARMXXX,XXX,XXXN/AMSC TOO FEW SETSMSC ID ERRORMSC FAILUREMSC DATA ERROR
Browse all Deep Sea Electronics fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for SD CAN SPEED DEMAND 250 on your specific Deep Sea Electronics unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.