MODULE STATUS CONFLICT

Possible Causes

• •Accessory module replaced with different module type
• •An accessory module has been replaced with a different type of module
• •One type of module is replaced with another type of module that has the same address
• •One type of module was replaced with another type of module that has the same address

Suggested Actions

1. 1Close the enclosure door and reconnect power to the ATS
2. 2Connect the new module
3. 3Disconnect power to the ATS
4. 4Disconnect power to the transfer switch
5. 5Disconnect the module
6. 6Follow the procedure in the Module Status Change section to uninstall the module through the ATS controller keypad when Check Module Setup to Clear Fault is displayed
7. 7Follow the procedure in the Module Status Conflict section to uninstall the old module and then install the new module
8. 8Navigate to the Set Auxiliary I/O screen to check the status and settings for the new module
9. 9Press the button labeled Reset to display Reset New Module, then press the reset button from that screen
10. 10Press the button labelled Reset when display shows Module Status Change
11. 11See Module Status Conflict section to correct
12. 12See the Module Status Conflict section to correct

Related Discovery Energy, LLC (Rehlko) Fault Codes