MODULE STATUS CHANGE

Possible Causes

• •A module has been disconnected
• •A new accessory module is detected
• •A new module is detected
• •An accessory module has been disconnected
• •Cable from controller to accessory module assembly is loose or disconnected
• •Communication to an installed I/O module has been lost
• •Failure of the controller's real-time clock
• •Installing one or more accessory modules
• •Installing or reconnecting one or more accessory modules
• •Loose or disconnected cable from the controller to the accessory module assembly
• •One or more accessory modules disconnected from the controller
• •One type of module is replaced with another type of module that has the same address
• •Real-time clock failure on controller board
• •Reconnecting one or more accessory modules

Suggested Actions

1. 1Attempt to reset the fault following standard reset procedures
2. 2Check I/O module connections
3. 3Check connections from the controller to the I/O module assembly and at the top of each I/O module
4. 4Close the enclosure door and reconnect power to the ATS
5. 5Connect the new module
6. 6Disconnect power to the ATS
7. 7Disconnect power to the transfer switch
8. 8Disconnect the module
9. 9Follow the procedure in the Module Status Change section to uninstall the module through the ATS controller keypad when Check Module Setup to Clear Fault is displayed
10. 10If a module has been removed, go to Set Inputs/Outputs screen and uninstall the module
11. 11If the procedures in the Module Status Change section fail to clear the error message, replace the controller
12. 12Navigate to the Set Auxiliary I/O screen to check the status and settings for the new module
13. 13Navigate to the Set Input/Outputs > Set Aux I/O screen to check that the controller has recognized the connected modules
14. 14Navigate to the Set Input/Outputs > Set Aux I/O screen to verify the controller recognizes the connected modules
15. 15Press Reset again
16. 16Press the Reset button on the ATS display
17. 17Press the Reset button on the Reset New Module screen
18. 18Press the Reset button when the ATS display shows 'Module Status Change'
19. 19Press the Reset button when the ATS display shows Module Status Change
20. 20Press the Reset button when the screen displays 'Reset New Module'
21. 21Press the button labeled Reset to display Reset New Module, then press the reset button from that screen
22. 22Press the button labelled Reset when display shows Module Status Change
23. 23Press the down arrow button on the Main screen to open the Reset Fault screen and press Reset
24. 24Press the reset button to open Reset New Module screen
25. 25Replace the controller if the fault cannot be reset
26. 26See Module Status Change section to reset
27. 27See the Module Status Change section to reset
28. 28Verify that the cable from the controller to the accessory module assembly is not loose or disconnected
29. 29Verify that the module is securely installed
30. 30When 'Check Module Setup to Clear Fault' appears, press the Reset button to clear the fault

Related Discovery Energy, LLC (Rehlko) Fault Codes