Rehlko

FAILURE TO ACQUIRE EMERGENCY SOURCE WARNING

UnclassifiedGeneral

What This Code Means

LEDs on the controller's user interface flash

Possible Causes

  • •Transfer switch does not sense voltage from the generator set within 78 seconds after signaling the generator set to start

Suggested Actions

  1. 1Check generator set operation
  2. 2Check connections from the generator set to the ATS
  3. 3Contact an authorized distributor/dealer for service if the fault persists

Related Rehlko Fault Codes

FAILURE TO ACQUIRE STANDBYFAULTFAILTOACQUIRESTBYFILE ERROR SHUTDWNFAILTOACQUIREPREFFREQ HIGH SHUTDWNEXTERNALFAULT(REMOTECOMMON ALARM)FREQUENCY HIGH SD *EXTERNALFAULT (REMOTECOMMONALARM)FREQUENCY HIGH WARNINGEXTERNALFAULTFREQUENCY LOW SD *
Browse all Rehlko fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for FAILURE TO ACQUIRE EMERGENCY SOURCE WARNING on your specific Rehlko unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.