AVR OVER-TEMP

UnclassifiedCooling

What This Code Means

Fan will not operate; AVR over-temp e-Code displays; Possible AVR failure

Possible Causes

  • •Voltage is not being supplied to the fan
  • •Voltage to the fan power supply is not available
  • •Voltage to the power supply is not available

Suggested Actions

  1. 1Check associated connections
  2. 2Connect test leads to Red wire (P1-19) and Black wire (P1-9)
  3. 3If reading is 0 VDC or less than 11.8 ± 0.5 VDC, proceed to inspect connector to the fan power supply located under the control panel
  4. 4If reading is approximately 11.8 ± 0.5 VDC, stop testing and refer back to flow chart (Auxiliary Power Supply Good)
  5. 5Locate the 20 pin connector (P1) at the AVR without disconnecting
  6. 6Set digital multimeter (DM) to measure DC Voltage
  7. 7Start generator in manual mode, run for 10 seconds, record highest voltage reading, and shut down
  8. 8Verify the integrity of the large fan
  9. 9Verify the voltage output to the fan

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for AVR OVER-TEMP on your specific Generac unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.