2751
What This Code Means
E-Stop button pressed; AUX shutdown; Hall calibration not performed on power up; Alarm triggered; ECU reports J1939 CAN diagnostic fault message; Battery voltage level < 9.0 for 60 seconds; System triggered alarm; E-Stop button pressed and shutdown; Problem 37; Problem 38; Problem 39; Problem 36; Over current cylinder 9 for one second; Over current cylinder 10 for one second; Under current cylinder 1 for one minute; Under current cylinder 2 for one minute; Under current cylinder 3 for one minute; Under current cylinder 4 for one minute; Under current cylinder 5 for one minute; Under current cylinder 6 for one minute; Under current cylinder 7 for one minute; Under current cylinder 8 for one minute; Under current cylinder 9 for one minute; Under current cylinder 10 for one minute; Internal ignition: no cam pulses detected after cranking for four seconds on gaseous unit; External ignition: no cam pulses detected; Internal ignition: missing crank pulses detected; External ignition: missing
Possible Causes
- •E-Stop button was pressed
- •AUX shutdown
- •Hall calibration was not performed on power up
- •J1939 CAN diagnostic fault message
- •Very low battery
- •E-Stop button pressed
- •Hall calibration not performed
- •Over current cylinder9 Coil current too high for one second.
- •Over current cylinder10 Coil current too high for one second.
- •Under current cylinder1 Coil current too low for one minute.
- •Under current cylinder2 Coil current too low for one minute.
- •Under current cylinder3 Coil current too low for one minute.
- •Under current cylinder4 Coil current too low for one minute.
- •Under current cylinder5 Coil current too low for one minute.
- •Under current cylinder6 Coil current too low for one minute.
- •Under current cylinder7 Coil current too low for one minute.
- •Under current cylinder8 Coil current too low for one minute.
- •Under current cylinder9 Coil current too low for one minute.
- •Under current cylinder10 Coil current too low for one minute.
- •Internal Ignition Missing Cam Cranked for four seconds on gaseous unit, no cam pulses detected.
Suggested Actions
- 1Problem 37
- 2Problem 38
- 3Problem 39
- 4Problem 36
- 5Problem 26
- 6The system detected battery voltage level < 9.0 for 60 seconds and has triggered the alarm.
- 7Warning will auto-clear after 60 seconds. Power cycle controller
- 8Problem 30 – Inspect Battery* page 139
ASK RUDY ABOUT THIS FAULT
Get a diagnosis walkthrough for 2751 on your specific Generac unit — cited to the OEM manual, not a forum guess.
TRY IT FREE