VOLTS L1-L2 LOW SD
UnclassifiedElectrical
What This Code Means
Generator voltage low; Output voltage falls below 80% of the nominal system voltage for more than 10 seconds; Engine cooldown runs before shutting down
Possible Causes
- •Ausgangsspannung beträgt länger als 10 Sekunden weniger als 80 % der Systemnennspannung
- •De uitgangsspanning is lager dan 80% van de nominale spanning van het systeem gedurende langer dan 10 seconden
- •El voltaje de salida cae bajo el 80 % del voltaje nominal del sistema durante más de 10 segundos
- •Excessive load
- •Output voltage falls below 80% of the nominal system voltage for more than 10 seconds
- •Tripped enclosure thermostat (Model 20RESC/20RESCL only)
- •Uitgangsspanning lager dan 80% van de nominale spanning gedurende langer dan 10 seconden
Suggested Actions
- 1Allow engine cooldown to run before shut down
- 2Bei einem autorisierten Distributor oder Händler um Service anfragen
- 3Bei einem autorisierten Distributor oder Händler um Service anfragen.
- 4Check enclosure thermostat and reset if tripped (Model 20RESC/20RESCL only)
- 5Contact an authorized distributor/dealer for service
- 6Contacte con un distribuidor o proveedor autorizado para solicitar mantenimiento
- 7Last verringern und Stromerzeuger-Aggregat neu anlassen
- 8Last verringern und Stromerzeuger-Aggregat neu anlassen.
- 9Neem contact op met een erkende distributeur/dealer voor onderhoud
- 10Reduce the load and restart the generator set
- 11Reduzca la carga y reinicie el grupo electrógeno
- 12Verminder de belasting en start de generatorset opnieuw
Related Rehlko Fault Codes
ASK RUDY ABOUT THIS FAULT
Get a diagnosis walkthrough for VOLTS L1-L2 LOW SD on your specific Rehlko unit — cited to the OEM manual, not a forum guess.
GET THE ANSWER
Free account required — we'll bring your question with you.