SCR SYS ERR

UnclassifiedGeneral

What This Code Means

Stage 1 Warning (DEF Indicator ON); Stage 2 Warning (DEF Indicator Slow Blinking, Pre-Alarm Lamp ON); Stage 3 Shutdown (DEF Indicator Fast Blinking, Pre-Alarm Lamp ON, Shutdown Lamp ON); Emergency shutdown; Intermittent operation; Unit requires up to 30 minutes to restart

Possible Causes

  • •Disconnection of sensors
  • •Escape Mode timer expires (30-minute limit)
  • •Improper usage
  • •No supply of DEF
  • •Problems with DEF dosing
  • •SCR system fault requiring maintenance
  • •SCR system fault requiring temporary emergency run (Escape Mode)
  • •Use of poor quality DEF
  • •Warnings are ignored
  • •Warnings ignored
  • •Warnings ignored leading to intermittent operation

Suggested Actions

  1. 1Enter ESCAPE MODE if emergency protective measures are necessary (allows restart, may require up to 30 minutes)
  2. 2Enter ESCAPE MODE if emergency protective measures are necessary (note: unit may require up to 30 minutes to restart)
  3. 3Enter ESCAPE MODE if emergency protective measures are necessary to allow restart
  4. 4Perform inspection and repair promptly
  5. 5Perform maintenance to return the unit to proper operating condition
  6. 6Place the Auto Start/Stop switch in the MANUAL position to start the engine
  7. 7Place the Auto Start/Stop switch in the OFF/RESET position
  8. 8Press the [REQUEST] button to send the Escape Mode Request signal to the ECM
  9. 9Press the [SELECT] button to enter the Escape Mode menu
  10. 10Replace DEF filter in the urea SCR system supply module every 1,000 hours of operation
  11. 11Replace the DEF filter (located in the urea SCR system supply module) every 1,000 hours of operation
  12. 12To temporarily bypass the shutdown and run in emergency reserve, request Escape Mode: Press [SELECT] to enter the 'Escape Mode' menu, press [REQUEST] to send the request to the ECM, place the Auto Start/Stop switch in the OFF/RESET position, and then place it in the MANUAL position to restart the engine.

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for SCR SYS ERR on your specific Multiquip Inc. unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.