EMPTY

UnclassifiedStarting

What This Code Means

Diagnostic Display shows CANBUS FAILURE; Diagnostic Display shows NO DATA; Diagnostic Display shows NOT SUPPORTED; Diagnostic Display shows DATA ERROR; Diagnostic Display shows EMPTY; Diagnostic Display shows WAIT TO START PREHEATING; Diagnostic Display shows TIMEOUT ECU NOT RESPONDING; Diagnostic Display shows NO GAGE DATA

Possible Causes

•Diagnostic Display has not received any CAN messages for at least 30 seconds
•Diagnostic Display has not received the particular message being displayed for at least 5 seconds
•Diagnostic Display has received a message from the ECU stating the displayed message is not supported
•Diagnostic Display has received an error message from the ECU for the displayed message
•No parameter selected for this 4-UP quadrant
•Engine is in a preheating cycle
•The ECU did not respond to the PowerView request
•The Diagnostic Display has no record of connected gages to the RS485 bus

Suggested Actions

1Wait until this message clears before starting the engine

Related Multiquip Fault Codes

NO DATA NO GAGE DATA EMERGENCY STOP NOT SUPPORTED E-STOP FAULT OVER-CRANK LED E-STOP TIMEOUT ECU NOT RESPONDING DATA ERROR WAIT TO START PREHEATING CANBUS FAILURE ERR

Browse all Multiquip fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for EMPTY on your specific Multiquip unit — cited to the OEM manual, not a forum guess.

TRY IT FREE