E-CODE 2126

UnclassifiedGeneral

What This Code Means

Alarm present; Alarm returns after clearing

Possible Causes

  • •Damaged OLS sensor float
  • •Damaged ECM or ECM harness pins
  • •Damaged OLS or OLS harness pins
  • •Wire 899 resistance greater than 5 ohms or open circuit (OL)
  • •Wire 820A resistance greater than 5 ohms or open circuit (OL)

Suggested Actions

  1. 1Unbolt and inspect OLS sensor; replace sensor if float is damaged and retest
  2. 2Inspect ECM and ECM harness pins; replace ECM harness and/or ECM if pins are damaged and retest
  3. 3Inspect OLS and OLS harness pins; replace OLS and/or wiring harness if pins are damaged and retest
  4. 4Measure resistance on Wire 899 between ECM and OLS; replace wiring harness if resistance measures greater than 5 ohms or reads OL and retest
  5. 5Measure resistance on Wire 820A between ECM and OLS; replace wiring harness if resistance measures greater than 5 ohms or reads OL and retest

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for E-CODE 2126 on your specific Generac unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.