BE-8 190 15
UnclassifiedCooling
What This Code Means
Fuel temperature sensor defect; Loss of engine angle and speed determination; Poor crankshaft or camshaft signal plausibility and quality; Missing crankshaft speed signal; Engine overspeed detection; Unacceptably high engine speed; Engine shut down after countdown timer elapses; Engine shut down after countdown timer falls below calibrated timer (CoEng_stIdlShDwnStM_mp=1); Electric failure in the Stop Lamp; Electric failure in the Warning Lamp; Overspeed detection; Engine shut down; Engine shut down after countdown; Electric failure of Stop Lamp; Electric failure of Warning Lamp
Possible Causes
- •Unreliable fuel temperature sensor
- •Camshaft and crankshaft sensor evaluation failure
- •Error in the ECM
- •Downhill travel (misuse of the engine)
- •Countdown timer elapsed (CoEng_stIdlShDwnStM_mp=3)
- •Triggered by Fid_CoEngIdleShDwnLvl2
- •Engine coordinator stop function input conditions met (based on engine speed, vehicle speed, vehicle speed sensor defect, engine start status, parking brake switch status, or stop switch input)
- •Hardware-detected electric failure in the Power stage of Stop Lamp
- •Hardware-detected electric failure in the Power stage of Warning Lamp
- •Sensor defect
- •Operating states like downhill travel (misuse of the engine)
- •Countdown timer has elapsed (CoEng_stIdlShDwnStM_mp=3)
- •Countdown timer is below a calibrated timer (CoEng_stIdlShDwnStM_mp=1)
- •Power stage of Stop Lamp electric failure detected by hardware
- •Power stage of Warning Lamp electric failure detected by hardware
Suggested Actions
- 1Take a fixed value as a substitution (depending on data set configuration and sensor reliability)
- 2Take the actual engine temperature as a substitution (depending on data set configuration and sensor reliability)
- 3Use a substitute fix value or the actual engine temperature (depending on configuration by data set and sensor reliability)
Related Winco Fault Codes
ASK RUDY ABOUT THIS FAULT
Get a diagnosis walkthrough for BE-8 190 15 on your specific Winco unit — cited to the OEM manual, not a forum guess.
TRY IT FREE