Deep Sea Electronics

ALARM 60

UnclassifiedGeneral

What This Code Means

Maintenance alarm active as a warning (set continues to run); Maintenance alarm active as a shutdown (running the set is not possible)

Possible Causes

  • •Configurable engine maintenance schedule reached (Oil, Air, or Fuel)

Suggested Actions

  1. 1Perform the required engine maintenance
  2. 2Activate an input configured to Maintenance Reset Alarm x (where x is Air, Fuel, or Oil)
  3. 3Press the maintenance reset button in the DSE Configuration Suite SCADA | MAINTENANCE section
  4. 4Press and hold the Stop/Reset Mode button for 10 seconds on the desired Maintenance Alarm status page (may require PIN)

Related Deep Sea Electronics Fault Codes

CAN 1 NODE LOST 180CAN ECU DATA FAILAIR FILTER MAINTENANCE ALARMCAN ECU SHUTDOWNCAN ECU WARNINGCHECK ENGINECOOLANT TEMP HIGH SHUTDOWNCOOLANT TEMPERATURE HIGHCOOLANT TEMPERATURE SENDER OPEN CIRCUITDELAYED OVER CURRENTEMERGENCY STOPFUEL FILTER MAINTENANCE ALARM
Browse all Deep Sea Electronics fault codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for ALARM 60 on your specific Deep Sea Electronics unit — cited to the OEM manual, not a forum guess.

TRY IT FREE