AC / DC DISPLAY ICON FLASHING

Possible Causes

• •Unit turned off
• •AC or DC output turned off
• •AC circuit breaker OPEN
• •Unit is overloaded
• •Unit temperature is below -4 °F (-20 °C)
• •Unit temperature is above 104 °F (40 C°)
• •AC or DC circuit error
• •Unit is defective
• •Bad power source
• •Loose connection
• •Unit temperature is below 32 °F (0 °C)
• •Unit temperature is above 104 °F (40 °C)
• •Defective charger
• •Power station powered ON incorrectly
• •Battery at 0% state of charge
• •No load present on unit
• •Display sleeps after 10 minutes
• •Power station automatically shuts down after 60 minutes to conserve battery

Suggested Actions

1. 1Hold ON/OFF power button on the power station.
2. 2Press AC or DC button to power on circuit.
3. 3Reset circuit breaker.
4. 4See Know Power Station Limits.
5. 5Move power station inside to warm up. (This may take some time.)
6. 6Move power station to cooler location. (This may take some time.)
7. 7Hold AC or DC button for three (3) seconds to reset circuit.
8. 8Contact IASD.
9. 9Confirm power source is compatible with the power station.
10. 10Check that plugs are firmly connected.
11. 11Hold ON/OFF button for three (3) seconds to power ON the power station.
12. 12Charge the power station.
13. 13Hold ON/OFF button to power on the power station.

Related Generac Fault Codes