8902

UnclassifiedGeneral

What This Code Means

UEGO1 Heater Supply High Voltage

Possible Causes

  • •Short to Vbattery in harness
  • •UEGO heater element has short

Suggested Actions

  1. 1Disconnect the harness from the ECM and check the heater control signal (between Pin 3 of the UEGO sensor and Pin 75 of the ECM) for a short to Vbattery using a DMM checking one pin at a time to the positive battery terminal
  2. 2Disconnect the harness from the UEGO Sensor and ECM and measure the heater resistance with a DMM (between pins 3 and 4 for Bosch sensor)
  3. 3Perform the On-Board (OBD) System Check
  4. 4Repair short to Vbattery in harness
  5. 5Replace ECM
  6. 6Replace UEGO sensor if heater resistance is less than 0.5 ohms

Related Power Solutions International, Inc. Fault Codes

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 8902 on your specific Power Solutions International, Inc. unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.