234

UnclassifiedGeneral

What This Code Means

Engine has exceeded normal operating speed (exceeded 1725 RPM at 50 Hz or 2075 RPM at 60 Hz); OVERSPEED lamp illuminated / Shutdown

Possible Causes

  • •A fault simulation was enabled with a PC based service tool
  • •Critical shutdown fault generated
  • •Engine exceeded normal operating speed
  • •Engine exceeded normal operating speed (above 1725 RPM at 50 Hz or 2075 RPM at 60 Hz)
  • •Fault simulation feature is enabled
  • •Faulty engine harness - general
  • •Faulty engine speed sensor connections
  • •Flammable vapors drawn into the intake air passage
  • •Incorrect fuel type setting
  • •Incorrect threshold setting
  • •Overspeed
  • •Single step large block load removal
  • •The engine is cold (no coolant heaters)
  • •The fault threshold is not set correctly with the PC based service tool

Suggested Actions

  1. 1Clear the fault and restart the genset
  2. 2Connect InPower and verify that fault simulation is not enabled for the engine speed sensor
  3. 3Connect InPower and verify the fuel source set is the same fuel used by the generator
  4. 4Contact an authorized service center for assistance
  5. 5Disconnect engine harness connector from extension harness and inspect engine harness connector pins for corroded, bent, broken, pushed back, or expanded pins
  6. 6Disconnect engine harness connector from the engine speed sensor and inspect connector pins for corroded, bent, broken, pushed back, or expanded pins
  7. 7If you do not have PC based service tool, remove battery power from the control to disable fault simulation overrides
  8. 8Inspect engine speed sensor connector for evidence of moisture, missing or damaged seals, and dirt or debris
  9. 9Locate and correct the problem
  10. 10Recalibrate the base board (PCC) to reset threshold settings
  11. 11Reset the control and restart the engine
  12. 12Reset the threshold to the highest allowable setting
  13. 13Use an engine service tool such as Insite or CalTerm III to change threshold settings
  14. 14Use service tool to connect to the base board (PCC), verify fault threshold settings, and compare to specifications in the engine manual
  15. 15Verify PCC calibration number and revision is correct
  16. 16With a PC based service tool, verify that the fault simulation is not enabled for the coolant sensor

ASK RUDY ABOUT THIS FAULT

Get a diagnosis walkthrough for 234 on your specific Cummins unit — cited to the OEM manual, not a forum guess.

GET THE ANSWER

Free account required — we'll bring your question with you.